Preparation before installation

Before installation, check whether the bird repeller parts are intact, turn on the power switch to test whether the bird repeller is on and working normally.

Installation

1、Place the bird repeller with the solar panel facing upwards in the bird protection location.

2、If you need to fix it, you can refer to the schematic diagram to fix the bird repeller in the target position. Lift the laser module box on all sides to a parallel angle with the solar panel. The photosensitive element at the bottom of the host when installing, can not be blocked.

Three, power on

After installing the bird repeller, turn the power switch on, the indicator light will light up and chirp, and the laser will flash at the same time. Then the bird repeller enters the working state.

Four, maintenance

1, daily inspection, should observe the bird repeller working indicator status is normal every 3 seconds light, found problems in time for maintenance.

2, in the event of prolonged rainy weather, so that the battery voltage is too low bird repeller stop working, the weather is good automatically through the solar energy charging, about 2-3 days bird repeller automatically return to work. This process is automatic, no need to turn off the bird repeller.

Precautions

1、please do not put your ear close to the bird repeller to listen to its sound. It is strictly prohibited to look directly at the laser emission hole to prevent injury.

2、Please do not open the bird repeller case without authorization, which is an important safety setting of the equipment.

3、If liquid leakage is found inside the chassis, the battery should be replaced immediately to avoid further damage.

4、The bird repeller is equipped with two specifications of fixing clamps to adapt to different specifications of fixing parts to ensure safe and stable use.